Remote Control - Q-See QT426 User Manual

GETTING STARTED

2.4 Remote Control

The remote control uses two AAA size batteries. Instructions for operation are as follows:
Step 1: Open the cover of the Remote Control
Step 2: Place batteries making sure the poles are correct (+ and -)
Step 3: Replace the battery cover
If the remote does not work check the following:
1. Check the pole position of the batteries
2. Check the remaining charge in the batteries
3. Check to make sure the sensor on the DVR is clear
4. If it still doesn't work, contact Q-See for a replacement
Figure 2-5 below illustrates the Remote Control functions as follows:
ITEM
PHYSICAL CONNECTOR
NUMBER
1 POWER BUTTON
2 INFO BUTTON
3 REC BUTTON
4 NUMBER BUTTONS
5 MULTI SCREEN BUTTON
6 SEARCH BUTTON
7 MENU BUTTON
8 ENTER BUTTON
9 DIRECTION BUTTON
Fig 2.5 Remote Control
CONNECTOR DESCRIPTION
Soft switch off to stop firmware running. Use this prior to turning off the
DVR.
Get information about the DVR like firmware version, HDD information
To record manually
Input numbers or choose camera
To choose multi screen display mode
To enter search mode
To enter menu
To confirm the choice or setup
Move cursor in setup or move PTZ camera
11 | P a g e
QT426 User Manual