Changing Bulb For Turn Signals; Changing Bulb For Front Fog Lights - Audi S5 Owner's Manual

document_0900452a81793dcc.book Seite 268 Mittwoch, 21. März 2007 5:42 17
268 Fuses and bulbs
Installing
– Perform all of the above steps in reverse sequence.
The headlight must be inserted in two guides (on the underside of
the headlight). This is the only way to ensure that the headlight is
installed in the correct position. To determine whether the headlight
is correctly installed, check that it is aligned flush with adjacent
body parts (such as the wing panel).
Do not interchange the securing screws.
Caution
Please take particular care not to damage or scratch the adjacent
parts of the body when removing or installing the headlights.
Applies to vehicles: with xenon headlight bulbs

Changing bulb for turn signals

The bulb is secured in the bulb carrier with a bayonet
fastener.
– Remove the headlight ⇒ page 267.
– Take off the rubber cap (small cover) and remove the bulb
carrier.
– Lightly press the defective bulb into the bulb carrier, then
turn it anti-clockwise and remove it.
– Do not touch the glass part of the new bulb with your
bare hands, use a cloth or paper towel instead.
– Fit the new bulb, pressing it into the bulb carrier, and turn
it clockwise as far as it will go.
– If necessary, use a cloth to remove any fingerprints from
the glass part of the bulb.
– Insert the bulb carrier into the headlight.
Note
Ensure that the rubber cap is seated correctly so that no water can
enter the unit.

Changing bulb for front fog lights

Preparations
Fig. 248 Trim cover for
fog light
Fig. 249 Screws
securing fog light