Renewing Bulb For Turn Signal - Audi 2003 A8 Workshop Manual

All vehicles (continued):
– Release retaining tabs -arrows- and detach main beam hous‐
ing cover from headlight housing.
– Release bulb holder for side light by pressing down handle at
holder -arrow 1-.
– Pull bulb holder for side light out of headlight housing
-arrow 2-.
– Pull bulb for side light -1- out of bulb holder -2-.
Installing
Installation is carried out in the reverse order; note the following:
– Insert new bulb in bulb holder, taking care not to touch glass
bulb with bare hands.
– Press bulb holder into reflector until you feel it engage.
– Close housing cover.
2.8

Renewing bulb for turn signal

Removing
– Switch off ignition and take out ignition key.
– Remove appropriate front wheel.
– Remove relevant front wheel housing liner ⇒ Rep. gr. 66 .
– Loosen locking bolt -1- a few turns.
– Release retaining tabs -arrows- and detach housing cover for
dipped beam headlights from headlight housing.
Electrical system - Edition 08.2014
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A8 2003 ➤
135
2. Halogen headlights