Audi S5 Owner's Manual page 136

document_0900452a81793dcc.book Seite 134 Mittwoch, 21. März 2007 5:42 17
134 Audi parking system
To ensure that the acoustic parking aid works properly, the
sensors and the lens of the reversing camera must be kept clean
and free of snow and ice. Please observe the additional notes from
⇒ page 143 onwards.
Please refer to the notes on towing ⇒ page 138.
Applies to vehicles: with parking system advanced
Reversing camera (Rear View)
The reversing camera image in the MMI display shows the
area behind the vehicle.
Parking mode
There are two different parking modes available when you park your
vehicle with the help of the reversing camera. These are referred to
as "Parking mode 1" ⇒ page 136 and "Parking mode 2" ⇒ page 137.
"Parking mode 1" ⇒ fig. 145 can, for example, be used when
parking your vehicle in a carport or a garage ⇒ page 136.
"Parking mode 2" ⇒ fig. 146 can be used, for example, when
parking your vehicle at the roadside ⇒ page 137.
When you activate the reversing camera ⇒ page 131 the MMI
display will automatically show "Parking mode 1". You can switch to
"Parking mode 2" by pressing the control button Mode
⇒ page 136, fig. 150. Press the control button Mode repeatedly to
switch between "Parking mode 1" and "Parking mode 2".
Orientation lines and area markings
Orientation lines and area markings (⇒ page 136, fig. 149 and
⇒ page 137, fig. 151) are also projected onto the reversing camera
images. They differ, depending on the parking mode you have
selected. These orientation markings are intended to assist the
driver when parking and manoeuvring in tight spaces. They are
Fig. 145 Viewed from
projected onto the image at road surface level (not on a gradient).
above: Parking mode 1
At the latest when the orientation lines and blue area markings
overlap with vehicles or other objects the distance to the vehi-
cles/objects is no longer sufficient ⇒ page 142.
The orientation lines and blue area markings will not be displayed if
the boot lid is open or the factory-fitted power socket for the trailer
is in use ⇒ page 138. This may not apply if the power socket was
NOT factory-fitted.
You can adjust the settings in the MMI to select which system you
want to be displayed on the MMI screen ⇒ page 140:
Fig. 146 Viewed from
above: Parking mode 2
Graphic display, or
Reversing camera images (Rear View), or
Automatic (switches automatically between graphic display and
reversing camera), or
A
A