Axis 16852 User Manual page 53

User's Manual
Upgrading the
AXIS OfficeBasic
Notes:
Follow the instructions below to upgrade the AXIS OfficeBasic
flash memory with an updated firmware version:
1. Log in to the AXIS OfficeBasic with the command:
ftp <host name>
2. You will be prompted for user id and password. Use the user id
, which has the default password
root
3. Type the command
4. Type the command
<software name>
e.g.
office_6xx.bin
5. Wait for the Flash loading operation to finish. This normally
takes 1 to 4 minutes. The unit automatically restarts with the
new print server software.
6. Log out using the command
your FTP version.
If the upgrading process fails, just repeat the instructions
presented above.
If you lose contact with the AXIS OfficeBasic after an upgrade
failure, just restart the AXIS OfficeBasic to restore contact.
Should the network diode flash at half a second intervals, the
AXIS OfficeBasic cannot process any print jobs. In order to
leave this state, you must repeat the instructions presented
above.
Section 7: Upgrading the Software
, or
ftp <IP address>
pass
to change to binary transfer mode.
binary
put <software name> flash
is the name of the new print server software,
quit, bye
.
, where
or depending on
exit
53