Axis 16852 User Manual page 18

Section 2: Hardware Installation and IP address assignment
18
Set the ip address
using IPInstaller
Note:
If your print server does not appear in the serial number list, refer to
the AXIS IP JumpStarter online help files.
1. Download AXIS IPInstaller. It is available for free on
www.axis.com
2. Start the program.
3. Restart your print server and then select it's serial number in the
list on the screen.
If you don't know the serial number of your print server, you can
find it on the bottom label of your print server (it is the same
number as the server's MAC/Ethernet-address.)
If no serial numbers are displayed, try restarting your printserver
by turning the power off and then on again.
4. Fill in the print server's desired IP address. You can get the IP
address from your network administrator.
The IP address first three fields usually already have values.
(These two first fields should normally not be changed, else you
are setting an IP address outside your own network range.)
5. Click the "Set IP address" button to set the IP address. You will
see dialogs that inform you of what is happening. Within one
minute (normally 20 seconds) the IP setting will be finished,
otherwise a timeout will occur. Upon success AXIS IPInstaller will
display a success statement.
When a failure occurs a dialog will let you know what went
wrong.
6. Click the "Close" button when you have finished setting IP
addresses.
User's Manual