Axis 16852 User Manual page 48

Section 6: Management & Configuration
48
Factory Default
Follow the instructions below to reset the AXIS OfficeBasic to the
factory default settings:
Settings
1. Remove the Power Adapter to switch off the AXIS OfficeBasic
2. Remove the network cable.
3. Press and hold down the test button while you plug the Power
Adapter back in. Continue to hold down the test button until the
network indicator begins to flash at one-second intervals. This
should take about 5 seconds.
4. Release the test button and wait until the network indicator flashes
at least five times.
5. Press and hold down the test button again until the network
indicator remains constantly lit.
6. Disconnect the Power Adapter.
7. Insert the network cable.
8. Restart the AXIS OfficeBasic by reconnecting the Power Adapter.
Note:
All parameters except Node Address (NODE_ADDR), Internet Address (IP_ADDR) and
DHCP enabled or disabled (DHCP_ENABLE.) are reset. If you want to change the these
parameters, use any standard Web browser.
User's Manual