The More Connections Screen - ZyXEL Communications AMG1312-T Series User Manual

Table 12 Network Setting > Broadband > Internet Connection: Advanced Setup (continued)
LABEL
Sustain Cell Rate
Maximum Burst
Size
PPPoE Passthrough
MTU
MTU

6.3 The More Connections Screen

The AMG1312-T Series allows you to configure more than one Internet access connection. To
configure additional Internet access connections click Network Setting > Broadband > More
Connections. The screen differs by the encapsulation you select. When you use the Broadband >
Internet Connection screen to set up Internet access, you are configuring the first WAN
connection.
Figure 21 Network Setting > Broadband > More Connections
AMG1312-T Series User's Guide
DESCRIPTION
The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be
transmitted. Type the SCR, which must be less than the PCR. Note that system default
is 0 cells/sec.
Maximum Burst Size (MBS) refers to the maximum number of cells that can be sent at
the peak rate. Type the MBS, which is less than 65535.
If encapsulation type is PPPoE, select this to enable PPPoE Passthrough. In addition to
the Device's built-in PPPoE client, you can select this to allow hosts on the LAN to use
PPPoE client software on their computers to connect to the ISP via the device. Each
host can have a separate account and a public WAN IP address.
The Maximum Transmission Unit (MTU) defines the size of the largest packet allowed
on an interface or connection. Enter the MTU in this field.
For ENET ENCAP, the MTU value is 1500.
For PPPoE, the MTU value is 1492.
For PPPoA and RFC 1483, the MTU is 65535.
Chapter 6 Broadband
75