ZyXEL Communications AMG1312-T Series User Manual page 118

Chapter 8 Home Networking
Figure 48 Network Setting > Home Networking > LAN Setup
The following table describes the fields in this screen.
Table 31 Network Setting > Home Networking > LAN Setup
LABEL
LAN IP Setup
IP Address
Subnet Mask
Dynamic Route
Direction
Multicast
IGMP Snooping
DHCP Server State
118
DESCRIPTION
Enter the LAN IP address you want to assign to your AMG1312-T Series in dotted
decimal notation, for example, 192.168.1.1 (factory default).
Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your AMG1312-T Series automatically computes the
subnet mask based on the IP Address you enter, so do not change this field unless you
are instructed to do so.
RIP (Routing Information Protocol) allows a router to exchange routing information
with other routers. Select the RIP version from RIP1 and RIP2.
Use this field to control how much routing information the VDSL Router sends and
receives on the subnet. Select the RIP Direction from None, Both, IN Only and
OUT Only.
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to establish
membership in a multicast group. The AMG1312-T Series supports IGMP v1/IGMP
v2/IGMP v3. Select None to disable it.
Select Enabled to activate IGMP Snooping. This allows the AMG1312-T Series to
passively learn memberships in multicast groups. Otherwise, select Disabled to
deactivate it.
AMG1312-T Series User's Guide