Table of Contents
Advertisement
Micro SD Card Slot
2.3. Hardware Installation
2.3.1 Stand-alone Installation
To install an IVS-H125 and IVS-H125P stand-alone, on a desktop or shelf, simply complete the
following steps:
1. Attach video source to IVS-H125 / IVS-H125P
To use IVS-H125 and IVS-H125P, user must supply video source to IVS-H125 and IVS-H125P.
Connect the BNC terminal of camera to the IVS-H125 and IVS-H125P's video input and make
sure to power on camera first.
2. Plug-in Ethernet cable into RJ-45 connector
Connect an Ethernet cable to the LAN socket located on the IVS-H125 and IVS-H125P's
panel and attach it to the network.
3. Check the LAN LED
The LED is defined to identify LAN connection type. When LAN port is connected, the LED
will be green.
4. Connect RS-485 D+ and D- (option)
When users would like to apply a camera with P/T/Z function, they usually need to connect
their communication port (for camera control) through RS-485. After RS-485 was correctly
connected to D+ and D-, the remote users could control the camera movement through
internet.
5. Attach Audio source to IVS-H125 / IVS-H125P (option)
If user needs not only video stream but also audio stream, then the audio source should be
attached to IVS-H125 and IVS-H125P. Connect the audio device's line output to the
IVS-H125 and IVS-H125P's MIC-in and make sure to power on your camera or audio device
first.
6. Attach the power supply (IVS-H125 only)
Plug in power adapter and connect to power source. After power on, the Power LED (orange)
will turn on later. Once the Power LED turned on, it means the system is booting up
successfully. Furthermore, if you have a proper network connection, and access to the
camera, the LAN LED will flash green.
NOTE:
Only use the power adapter supplied with Video Server. Otherwise, the product
may be damaged.
again.
User can insert a micro SD card into this slot for recording.
14
User's Manual of IVS-H125 Series
Advertisement
Table of Contents
