Table of Contents
Advertisement
1.
Press the RESET button once. The Web Smart Switch will reboot automatically.
Notice:
2.
Press the RESET button for 5 seconds. The Web Smart Switch will back to the factory default
mode; the entire configuration will be erased.
2.2 Rear Panel
The rear panel of the Web Smart Switch indicates a DC power connector, which accepts input power of DC 5V 2A.
Power Notice:
1. The device is a power-required device, it means, it will not work till it is powered. If your networks should active all the
time, please consider using UPS (Uninterrupted Power Supply) for your device. It will prevent you from network data
loss or network downtime.
2. In some area, installing a surge suppression device may also help to protect your Web Smart Switch from being
damaged by unregulated surge or current to the Web Smart Switch.
2.3 Hardware Installation
This part describes how to install your Web Smart Switch and make connections to the Switch. Please read the following
topics and perform the procedures in the order being presented. To install your Web Smart Switch on a desktop or shelf,
simply completed the following steps.
2.3.1 Desktop Installation
To install Web Smart Switch on a desktop or shelf, simply completed the following steps:
Step 1: Attached the rubber feet to the recessed areas on the bottom of the Web Smart Switch.
Step 2: Place the Web Smart Switch on a desktop near an DC power source.
Step 3: Keep enough ventilation space between the Web Smart Switch and the surrounding objects.
When choosing a location, please keep in mind the environmental restrictions discussed in
Notice:
Chapter 1, Section 4, Specification.
Step 4: Connect your Switch to POF devices / network devices
A.
Connect one end of a POF cable to the 100Base-FX POF ports on the rear panel of the Web Smart Switch.
B.
Connect one end of a standard network cable to 100Base-FX POF ports from other POF devices.
C.
Connect one end of a standard network cable to the 1000Base-T RJ-45 port on the rear of the Web Smart Switch.
D.
Connect the other end of the cable to the network devices such as printer servers, workstations or routers...etc.
Connection to the Web Smart Switch requires Plastic of Fiber / UTP Category 5 network cabling
Notice:
with RJ-45 tips. For more information, please see the Cabling Specification in Appendix A.
Step 5: Supply power to the Web Smart Switch.
A.
Connect one end of the power cable to the Web Smart Switch.
B.
Connect the DC 5V power adapter to the Web Smart Switch and power on the Web Smart Switch.
When the Web Smart Switch receives power, the Power LED should remain solid Green.
Figure 2-2 FSD-624SF Switch rear panel
- 9 -
Advertisement
Table of Contents
