Table of Contents
Advertisement
6. Hardware Installation
The following section describes the hardware features of the IPOE-171
series. Before connecting any network device to it, please read this
chapter carefully.
6.1 Before Installation
Before your installation, it is recommended to check your network
environment. If there is any IEEE 802.3bt device that needs to be
powered on and works normally, the IPOE-171 series is the solution
that supplies power to this Ethernet device conveniently and easily. If
there is difficulty in finding a power socket for the AC-DC connection
to your non-IEEE 802.3af/at/bt networked device, the IPOE-171 series
with POE-172S / IPOE-171S can supply DC power to this Ethernet
device conveniently and easily.
1. In the installation steps below, this manual uses the
IPOE-171-60W as an example. Except the input
voltage, the steps for the IPOE-171-95W are similar.
2. Note that the input power range of the IPOE-171-60W
Note
is 48 ~ 56V DC and the input power range of IPOE-
171-95W is 24 ~ 48V DC.
6.2 IPOE-171-60W Installation
1. Connect the power ranging from 48V DC to 56V DC to the 6-pin
terminal block of the IPOE-171-60W. The power LED will be steadily
on.
2. Connect a standard Ethernet cable from an Ethernet switch or PC
workstation to "Ethernet" port of the IPOE-171-60W.
3. Connect the long cable to the "Ethernet+DC" port.
20
Advertisement
Table of Contents
