Brother MFC-4820C User Manual page 330

DIFFICULTY
Printing is slow.
Colour Enhancement is not
working correctly.
'MFC is Busy' or 'MFC
Connect Failure' Error
Message appears.
'MFC Connect Failure'
™
PhotoCapture Center
Removable Disk does not
work properly.
23 - 10 TROUBLESHOOTING AND ROUTINE MAINTENANCE
SUGGESTIONS
In the 'Colour' tab from the 'Advanced' tab in the printer driver, uncheck
the Colour Enhancement.
If the image data is not full colour in your application (Such as 256
colour), Colour Enhancement will not work. Please use at least 24 bit
colour data with the Colour Enhancement feature.
Make sure the MFC is not showing an error message on the LCD.
If the MFC is not connected to your PC and you have loaded the Brother
software, the PC will show 'MFC Connect Failure' each time you restart
®
Windows . You can ignore this message or you can turn it off by
deselecting the AutoLoad PopUp check box in the Brother Control
Center chapter. (See How to turn off AutoLoad on page 16-2.)
Difficulties
a) Have you installed the Windows
If not, do the following:
1. Disconnect the USB cable.
2. Install the Windows 2000
Guide. After the installation the PC will be automatically restarted.
3. Wait about 1 minute after you reboot the PC, and then connect the
USB cable.
b) Take out the media card and put it back in again.
c) If you have tried "Eject", you must take out the media card before you
continue.
d) If an error message appears when you try to eject the media card, it
means the card is being accessed.
Wait a while and then try again.
e) If all of the above do not work, please turn off your PC and MFC, and
then turn them on again.
(You will have to unplug the power cord of the MFC to turn it off.)
®
2000 update?
®
update. Please see the Quick Setup