Dual Access (Not Available For Colour Faxes) - Brother MFC-4820C User Manual

Dual Access (Not available for colour faxes)

You can dial a number, and begin scanning the fax into memory—
even when the MFC is receiving, sending or printing a fax from
memory. The LCD shows the new job number and available
memory.
If you get a OUT OF MEMORY message while scanning the first
page of a fax, press
OUT OF MEMORY message while scanning a subsequent page,
you can press
Stop/Exit
press
1
Place the original face down on the scanner glass.
2
Enter the fax number.
3
Fax Start
Press
The MFC starts scanning the first
page and the LCD shows the job number
(#XXX) of the fax and how much memory is available.
4
To send a single page,
2
press (or press
The MFC starts sending the original.
—OR—
To send more than one page,
1
press and go to Step 5.
5
Place the next page on the scanner
glass.
Menu/Set
Press
The MFC starts scanning, and then returns to Step 4. (Repeat
Steps 4 and 5 for each additional page). You can repeat Steps
1 to 5 for the next fax.
Your MFC normally uses Dual Access. However, to send a
colour fax, the MFC will send the original in real time (even if
REAL TIME TX is OFF).
The number of pages you can scan into the memory will vary
depending on the data that is printed on them.
6 - 10 SETUP SEND
Stop/Exit
Fax Start
to send the pages scanned so far, or
to cancel the operation.
to send the fax.
Fax Start
again).
.
to cancel scanning. If you get a
NEXT PAGE?
1.YES 2.NO(DIAL)
SET NEXT PAGE
THEN PRESS SET