Yamaha YBR250 Owner's Manual page 67

MOTORCYCLE CARE AND STORAGE
After normal use
Remove dirt with warm water, a mild
detergent, and a soft, clean sponge, and
then rinse thoroughly with clean water.
Use a toothbrush or bottlebrush for hard-
to-reach areas. Stubborn dirt and insects
will come off more easily if the area is
covered with a wet cloth for a few
minutes before cleaning.
After riding in the rain, near the sea or
on salt-sprayed roads
Since sea salt or salt sprayed on roads
during winter are extremely corrosive in
combination with water, carry out the
following steps after each ride in the rain,
near the sea or on salt-sprayed roads.
7
Salt sprayed on roads in the winter may
remain well into spring.
1. Clean the motorcycle with cold
water and a mild detergent, after
the engine has cooled down.
Do not use warm water since it
increases the corrosive action of the
salt.
2. Apply a corrosion protection spray
on all metal, including chrome- and
nickel-plated, surfaces to prevent
corrosion.
After cleaning
1. Dry the motorcycle with a chamois
or an absorbing cloth.
2. Immediately dry the drive chain
and lubricate it to prevent it from
rusting.
3. Use a chrome polish to shine
chrome, aluminum and stainless-
steel parts, including the exhaust
system. (Even the thermally
induced discoloring of stainless-
steel exhaust systems can be
removed through polishing.)
4. To prevent corrosion, it is
recommended to apply a corrosion
protection spray on all metal,
including chrome- and nickel-
plated, surfaces.
7 - 2
ECA10790
5. Use spray oil as a universal cleaner
to remove any remaining dirt.
6. Touch up minor paint damage
caused by stones, etc.
7. Wax all painted surfaces.
8. Let the motorcycle dry completely
before storing or covering it.
Make sure that there is no oil or
l l l l l
wax on the brakes or tires.
If necessary, clean the brake
discs and brake linings with a
regular brake disc cleaner or
acetone, and wash the tires with
warm water and a mild
detergent. Before riding at
higher speeds,
motorcycle's
performance and cornering
behavior.
Apply spray oil and wax
l l l l l
sparingly and make sure to wipe
off any excess.
l l l l l Never apply oil or wax to any
EWA11130
test the
braking
ECA10800