Tachometer; Multi-Function Display - Yamaha YBR250 Owner's Manual

Tachometer

1. Speedometer
2. Tachometer
The electric tachometer allows the rider
to monitor the engine speed and keep it
within the ideal power range.
When the key is turned to "ON", the
tachometer needle will sweep once
across the r/min range and then return
to zero r/min in order to test the electrical
circuit.
Do not operate the engine in the
tachometer red zone.
Red zone: 10.000 r/min and above
INSTRUMENT AND CONTROL FUNCTIONS
EAU11872

Multi-function display

TRIP
ODO
1. Display
2. "SELECT" button
3. "RESET" button
The multi-function display is equipped
with the following:
an odometer (which shows the total
l
distance traveled)
two tripmeters (which show the
l
distance traveled since they were
last set to zero)
a fuel reserve tripmeter (which
l
ECA10031
shows the distance traveled on the
fuel reserve)
a fuel meter
l
a clock
l
EAUW0150
Be sure to turn the key to "ON" before
using the "SELECT" and "RESET"
1
buttons.
Km
Odometer, tripmeter and clock
modes
Pushing the "SELECT" button switches
SELECT RESET
the display between the odometer
2 3
mode "ODO" and the tripmeter modes
"TRIP 1", "TRIP 2" and the clock mode
in the following order:
ODO → TRIP 1 → TRIP 2 → CLOCK →
ODO
If the fuel level warning light comes on
(see page 3-2), the odometer display will
automatically change to the fuel reserve
tripmeter mode "F-TRIP" and start
counting the distance traveled from that
point. In that case, pushing the
"SELECT" button switches the display
between the various tripmeter, odometer
and clock modes in the following order:
F-TRIP → TRIP 1 → TRIP 2 → CLOCK
→ ODO → F-TRIP
To reset a tripmeter, select it by pushing
3 - 3
3