Replacing A Turn Signal Light Bulb Or The Tail/Brake Light Bulb; Replacing The Auxiliary Light Bulb - Yamaha YBR250 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Replacing a turn signal light
bulb or the tail/brake light
bulb
1. Remove the lens by removing the
screws.
6
1.Screw
1
1. Screw
2. Remove the defective bulb by
pushing it in and turning it
counterclockwise.
EAU24281
3. Insert a new bulb into the socket,
push it in, and then turn it clockwise
until it stops.
4. Install the lens by installing the
screws.
Do not overtighten the screws,
otherwise the lens may break.
1
Replacing the auxiliary light
bulb
ECA10680
1. Auxiliary light bulb
If the auxiliary light bulb burns out,
replace it as follows.
6 - 2 8
1
1. Remove the headlight unit by
removing the screws.
2. Remove the socket (together with
the bulb) by pulling it out.
3. Remove the defective bulb by
pulling it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by pushing it in.
6. Install the headlight unit by
installing the screws.
EAU37270