Rear Wheel - Yamaha YBR250 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Tightening torque:
Wheel axle:
60 Nm (6.0 m.kgf, 44 ft.lbt)
5. Tighten the front fork pinch bolt to
the specified torque.
Tightening torque:
Front fork pinch bolt:
55 Nm (5.5 m.kgf, 40ft.lbt)
6. Push down hard on the handlebar
several times to check for proper
fork operation.
6

Rear wheel

To remove the rear wheel
l l l l l It is advisable to have a Yamaha
dealer service the wheel.
Securely support the motorcycle
l l l l l
so that there is no danger of it
falling over.
1. Loosen the axle nut and the brake
torque rod nut at the brake shoe
plate.
2. Lift the rear wheel off the ground
according to the procedure on page
6-29.
3. Disconnect the brake torque rod
from the brake shoe plate by
removing the nut and the bolt.
6 - 3 0
EAU25080
3
EAU25430
EWA10820
1. Drive chain slack adjusting nut
2. Brake torque rod
3. Locknut
4. Brake pedal free play adjusting nut
5. Axle nut
4. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod at the brake camshaft
lever.
5. Loosen the locknut and the drive
chain adjusting nut on both ends
of the swingarm.
6. Remove the axle nut, and then pull
the wheel axle out.
5
2
4