Setting The Mode To Execute Selfcalibration "Mode Selection - Eizo ColorEdge CG275W User Manual

●

Setting the mode to execute SelfCalibration "Mode Selection"

Set the mode to execute SelfCalibration (CAL1/CAL2/CAL3).
Signal input is specified for each set mode.
Mode
CAL1
CAL2
CAL3
Procedure
1. Choose "SelfCalibration" from the Adjustment menu, and press
2. Choose "Settings" from "SelfCalibration", and press
3. Choose "Mode Selection" from "Settings", and press
4. Use or to select the mode to change, and press
5. Select "On" or "Off" with
6. Press to exit.
Note
• allows you to check the mode currently available (CAL1/CAL2/CAL3).
• When "Other Modes" is set to "On", the monitor color reproduction area is updated and the display in each color
mode will be adjusted as follows:
- In any mode other than CAL mode, the temperature is adjusted so that it is as close as possible to the specified
value.
- In Adobe RGB/sRGB/EBU/REC709/SMPTE-C/DCI modes, the gamut values are adjusted so that they are close to
each specified value.
Signal inputs
DVI
DisplayPort-1
DisplayPort-2(MiniDisplayPort)
or .
.
.
.
.
Chapter4SelfCalibration
31