Table of Contents
Advertisement
3-8. Setting the Input Signals "Signal Selection"
Signals can be selected based on your operating environment.
Attention
• The graphics board supporting signal display is required.
• Refer to the User's Manual of the graphics board.
●
To connect DVI (Single Link)
Procedure
1. Press
to turn off the monitor.
2. Holding
The "Optional Settings" menu appears.
3. Choose "Signal Selection" from "Optional Settings", and press
4. Select "DVI" with
5. Select "Signal Format" with
6. Select "Single Link" with
7. Press
8. Select "Finish" with
9. Press
The "Optional Settings" menu is closed.
●
To connect DVI (Dual Link)
Procedure
1. Press
to turn off the monitor.
2. Holding
The "Optional Settings" menu appears.
3. Choose "Signal Selection" from "Optional Settings", and press
4. Select "DVI" with
5. Select "Signal Format" with
6. Select "Dual Link" with
7. Select "Signal Bandwidth" with
Use
or
to select or just confirm the signal bandwidth setting for the frequency that corresponds to your graphics
board.
Normal
Wide
8. Press
9. Press
10. Select "Finish" with
11. Press
The "Optional Settings" menu is closed.
26
Chapter3SettingMonitor
down, press
for at least two seconds to turn on the monitor.
or , and press
or , and press
or , and press
twice.
or .
.
down, press
for at least two seconds to turn on the monitor.
or , and press
or , and press
or , and press
or , and press
Horizontal scan frequency
Setting
26to89
26to89
.
twice.
or .
.
.
.
.
.
.
.
.
(kHz)
.
.
Vertical scan frequency (Hz)
59to61
23.75to63
Advertisement
Table of Contents
