Reports (Matrix-To-Host; Report0 (70H) - Status; Report1 (71H) - New Controlling Port - Extron electronics 100 User Manual

Reports (Matrix-to-Host)

Report0 (70h) - Status

Report1 (71h) - New Controlling Port

A-13
This report is broadcast when a change in internal status is detected.
Format:RPRT0, StsB1, StsB2, StsB3, 80h, 80h, 04h
Status Byte 1: 7
Bit usage: 1
Where: StsB1, Bit-0 Power On/Off status - 0 = powered on; 1 = powered off
StsB1, Bit-1 Backup battery status - 0 = battery okay; 1 = battery
low
StsB1, Bit-2 Genlock Signal - 0 = detected; 1 = not detected
StsB1, Bit-3 Vertical interval switching - 0 = disabled; 1 = enabled
StsB1, Bit-4 Slave status - 0 = stand alone unit or master controller
StsB1, Bit-5 Sequence running - 0 = not running; 1 = running
StsB1, Bit-6 Program status - 0 = no program event pending;
1 = program event pending (timer is set)
Status Byte 2: 7
Bit usage: 1
Where: StsB2, Bit 0 - Power Supply in use - 0 = Backup Power; 1 = Main Power
StsB2, Bit 2 - Hardware Security status - 0 = locked; 1 = unlocked
(available to user, when unlocked)
StsB2, Bits 1 and 3 thru Bit 6 are reserved (should be zero)
Status Byte 3: 7
Bit usage: 1
Where: StsB3 Bit 0 - Software Security status - 0 = locked; 1 = unlocked
(available to user, when unlocked)
StsB3 Bit-1 thru 6 are reserved (should be zero)
This report is broadcast when a change in the connections (current or presets)
or the operating mode is requested (and implemented) by a new port.
Commands CMD5, 7, 9, 11, 12, and 25 will cause this report to be sent.
Format:RPT1, Port#, 80h, 80h, 04h
Where: Port# as follows ...
80h host controller (RS-232/RS-422)
81h n/a
82h standard front panel controller port
83h secondary front panel controller port
Appendix A • RS-232 Matrix Programmer's Guide
6 5 4
Prg Seq Slv Ver
1 = slave in a compound matrix
6 5 4
0 0 0
6 5 4
0 0 0
Extron • Matrix 100 • User's Manual
3 2 1 0
Gnlk Batt Pwr
3 2 1 0
0 H-Sec 0 Ps
3 2 1 0
0 0 0 S-Sec