Figure 4-16. Plug The Ribbon Cables From Each Module To The Main Controller Board - Extron electronics 100 User Manual

Chapter 4 • Matrix 100 Hardware Installation
_________ When working close to the other I/O modules, be careful that you do not change

Figure 4-16. Plug the Ribbon Cables from each module to the Main Controller board.

_________ The red stripe on the ribbon cables (pin 1) is to the right, on the Main Controller
Extron • Matrix 100 • User's Manual
11. Plug the remaining I/O Ribbon cables from each module to a connector on
the Main Controller board. Since the Main Board connectors are the same,
connect the cables for neatness and convenience. For example, the
illustration below shows the Red I/O module connected to J5, the Blue to J6,
etc.
any other DIP switch settings.
12. Be sure the cables are securely plugged into the Main board, and then drop
the six screws into the six holes in the Audio Module. Wiggle each screw by
hand to align it with the threads below and tighten them with a screwdriver.
and Audio boards. (See the picture below.) It must point up on the other I/O
modules.
13. With all connections and screws secure, dress the cables away from the
power supplies. Use tie wraps to tie cables together where they follow the
same path.
14. If no other modifications are required, put the top cover back on the
Matrix 100 and put it back in its working position.
The new configuration will also appear in Request ID information sent to the
Host system via the RS-232 port.
If other modifications are required, go to the appropriate procedure.
4-8