Cmd5 (35H) - Set (Tie) Connection; Cmd7 (37H) - Set (Tie) All Connections - Extron electronics 100 User Manual

CMD5 (35h) - Set (Tie) Connection

CMD7 (37h) - Set (Tie) All Connections

_______ 1. The plane record has a length determined by the number of outputs (n).
A-9
The Host tells the Matrix to connect the specified output (Out#) to the specified
input (Inp#) in those planes specified by PlnMap0. (Plane maps are explained
earlier in this section.)
Format: CMD5, PlnMap1, PlnMap0, Out#, Inp#, 80h, 80h, 04h
Example: 35h, 80h, 87h, 83h 85h, 80h, 80h, 04h
This example will connect output #3 to input #5 in RGB planes.
PlnMap1 is not used at this time, therefore it will be 80h.
PlnMap0 = 87h (bits 0, 1, 2 = 1, 1, 1 for the Red, Green and Blue planes)
See Plane Map on previous page.
Out# = 83h = Output #3
Inp# = 85h = Input #5
Response: CMD5, Erc, 80h, 80h, 04h
The Host tells the Matrix to set connections for any (or all) planes in Matrix. The
planes must be specified by board address (BdAd), in sequential order. A preset
number is assigned for saving this configuration. The configuration may be
loaded later by selecting the preset number.
Format:CMD7, Preset, {(BdAd, Inp1, Inp2, .. Inpn, CR), ..}, 80h, 80h, 04h
Example: 37h, 82h, 80h, 83h, 83h, 85h, 80h, 80h, 80h, 81h, 81h, 0Dh, 81h...
80h, 80h, 04h
Where:
A) Preset is the number assigned to this configuration (example is preset
#2).
Preset numbers can be 1 - 8 (81h - 94h). If the information is to be used as
the current Matrix configuration, without saving it as a preset, the number
for this will be zero (80h).
B) (BdAd, Inp1, Inp2, .... Inpn, CR) is a string of bytes for each plane record,
with the following components:
a. BdAd is the board address for the plane (example is 80h = red
plane).
b. Inp1 is the input # to connect to output #1. (example ties input #3)
Inp2 is the input # to connect to output #2. (example ties input #3)
c. Inpn is the input# to connect to the last output. (example ties input
#1)
d. CR - carriage return (0Dh) terminates the data string for this plane.
C) Another plane record (data string) will follow for the next plane to be
configured - and another, etc. for each plane to be configured.
2. Only existing planes are valid.
3. Any, or all, valid planes may be specified in the same command.
4. Planes must be specified in ascending BdAd address order.
(Plane 1 first; plane n last.)
Response: CMD7, Erc, 80h, 80h, 04h
Possible Ercs: C0 = Out of memory space
Appendix A • RS-232 Matrix Programmer's Guide
Extron • Matrix 100 • User's Manual