Adding An Audio Module; Figure 4-11. How The Audio Module Fits In The Matrix; Figure 4-12. Audio Module Connections And Hardware - Extron electronics 100 User Manual

Chapter 4 • Matrix 100 Hardware Installation

Adding an Audio Module

_________ Do not do this procedure unless your Matrix 100 is up to date.
Tools for Installation:
3/16" flat screwdriver
#4 Phillips screwdriver
#6 Phillips screwdriver
Wire cutters
Audio Option Kit:
Qty - Description
1 - Audio Module ( )
6 - 0.685" Nylon Spacers ( )
6, 1-5/8 Screws ( )
3" Ribbon Cable ( )
16 - Phoenix Connectors ( )
Figure 4-12. Audio Module
connections and hardware
Extron • Matrix 100 • User's Manual
1. Remove the Matrix top cover (procedure on page 4-2).
2. Locate the gray ribbon cables that connect the Main Controller board to the
existing I/O modules (Red, Green, Blue and Sync/Composite Video). Note
the orientation of the red stripe on each ribbon cable and unplug both ends. If
necessary, cut the ties that bind them together. It is not necessary to mark
the cable connections; this will be covered later. Put the ribbon cables aside.
3. On the rear panel, remove the two screws (See
Figure 4-11.) that hold the right end of the blank cover.
(Tabs hold the left end.) Remove the cover and put the
screws back in the same holes. This reveals two long,
parallel access slots. These will accommodate the
upper and lower sections of the Audio Module.
Check the installation parts
list and identify them by their
location in Figures 4-11 and
4-12.
4. Unpack the six 0.685"
nylon spacers and slip
one over each of the six
mounting posts in the
bottom of the cabinet.
(See in Figure 4-11.)
in

Figure 4-11. How the Audio Module fits in the Matrix

4-6