Maintenance And Care; Cleaning; Flushing/Sanitizing; Surface Scratch Removal - Aquatic Serenity Series Owner's Manual & Installation Manual

mAiNTENANCE ANd CArE

CLEANiNg:

use common household, non abrasive cleaners for most cleaning jobs. clean grease, oil, paint and ink stains with
isopropyl (rubbing) alcohol. rinse well and dry with a clean cloth or sponge. do not run the air system with foaming
cleaners or soaps. rinse the bath thoroughly after cleaning. do not allow your Lucite® acrylic surface to come into
contact with products such as acetone (nail polish remover), nail polish, dry cleaning solution, lacquer thinners, gasoline,
pine oil or other toxic and oily cleaners.
FLuShiNg / SANiTiziNg:
Before tub is used, your air bath and plumbing system should be flushed. close the drain. Fill bath with hot water to
at least six inches above air injector holes. Add 2 teaspoons of low sudsing automatic dishwashing detergent and no
more than 4 ounces of bleach to the water. dO nOt use bleach or other chlorinated cleansers on metal trim surrounding
control panel. turn bath on for approximately two minutes to mix cleaner with water. shut blower down and allow
cleaner to soak in the bath for approximately two hours. turn on air bath and run for approximately five minutes. turn
air bath unit off and drain tub. Aquatic recommends the above cleaning process on your air bath once a month.

SurFACE SCrATCh rEmOVAL:

Minor scratches may be removed by polishing your tub with a non-abrasive car polish, followed by buffing. deeper
scratches can be removed by:
• Sanding with wet 400 grit sandpaper.
• Sanding with wet 600 grit sandpaper.
• Sanding with wet micro-grit sandpaper.
• Buff out using car polish.

rEPAir:

The installation and service of your air bath should be performed only by a qualified service technician. remember
when contacting your distributor always have your serial number, proof of purchase and model number available.
This will ensure a quick response on warranty items. See page 27 for serial number location.
NOTE: ALL wArrAntY rePAirs Must Be AutHOriZed BY AquAtic BeFOre wOrK is stArted. FOr serVice,
ALwAYs cOntAct YOur distriButOr Or AutHOriZed serVice center.
CAuTiON: care should be taken to prevent inappropriate chemicals coming in contact with the Lucite® acrylic surface.
Please read and observe all instructions and/or warnings on containers containing substances you contemplate applying
to your air bath. Any failure to comply may void your warranty.
wATEr ANd Air TEmPErATurE:
each serenity model is equipped with a 600 watt air heating system to raise the temperature of the air going into the
bath. this air temperature will be less than the bathing temperature of the water, but will help to reduce a rapid decrease
in water temperature. in addition, the air coming from the air jets will feel cool against the skin, just as a breeze on a
warm day cools your body. this system does not heat the water.
26 AquAtic industries, inc.