Aquatic Serenity Series Owner's Manual & Installation Manual page 15

iNSTALLATiON iNSTruCTiONS
SErENiTy 11 & 13 iNSTALLATiON:
Before the floor installation is complete, make sure the floor is
level. Once the floor installation is complete, determine the exact
location of the bath and trace the contour of the bath with an
erasable marker pen.
For information on electrical installation, maintenance and care, trou-
bleshooting and warranty, please refer to the table of contents.
1. determine the exact location of the drain, air passage and the
two anchoring points at each end of the bath (see diagram
10A for serenity 11 and 13).
2. drill 2" holes for the drain and air passage holes. to prevent
the bath from moving sideways, secure the two anchoring
pins (3/8" x 3" lag bolts) to the floor. Leave the lag bolts 1 1/2"
above floor. wipe off the marker tracings (see diagram 10d).
3. install the overflow and drain on the bath. cut pipes to desired
length prior to assembly. glue the first pipe section (PVc 1
1/2") of the air passage to go under the floor and make sure
pins are lined up with holes in tub. Apply a silicone seal under
the rim of the base and lay the bath down putting the pipes
through the floor. immediately remove any excess silicone (see
diagrams 10B and 10c).
10B
10d
Anchor Pins
20"
20 1/2"
SErENiTy 11 SidE ViEw
AquAtic industries, inc.
cut pipes to desired
length prior to assembly
10d
20"
Anchor Pin Holes
20 1/2"
20"
SErENiTy 11 BOTTOm ViEw
Anchor Pin Holes
20" 17"
SErENiTy 13 BOTTOm ViEw
10C
Anchor Pins
20"
17"
SErENiTy 13 SidE ViEw
10A
20"
22 1/2"
17 1/4"
Blower
Fitting
10A
20"
20 1/4"
16 1/2"
Blower
Fitting
20"
15