Installation Instructions For Freestanding Models - Aquatic Serenity Series Owner's Manual & Installation Manual

iNSTALLATiON iNSTruCTiONS
iNSTALLATiON OF FrEESTANdiNg mOdELS:
NOTE:
•
Freestanding units must be placed on a perfectly leveled
floor.
•
the blower must be mounted in a remote location and
cannot be installed on the bath (see pages 17 and 18).
•
wall mounted or freestanding faucets must be used.
SErENiTy 10 & 37 iNSTALLATiON:
For information on electrical installation, maintenance and
care, troubleshooting and warranty, please refer to the table
of contents.
Before the floor installation is complete, make sure it is perfectly
level. Once the floor installation is complete, determine the
exact location of the bath and mark the floor position of the
four claw feet (see diagram 9A). The bath must be anchored
to the floor. Also, mark the position of the holes to be drilled
for the blower air passage and drain.
1. drill four holes for the feet. then drill a 2" hole for the air
passage and 2" hole for the drain.
2. install the drain and overflow on the bath. cut pipes to desired
length prior to assembly. next, glue the first section of pipe
(PVc 1 1/2") to the air passage under the tub and then
cover the pipe with the pipe concealer (see diagram 9B).
3. Once the pipe has been installed through the floor and the
bath has been placed, secure the four feet with 1/4" lag
bolts or concrete anchors (see diagram 9c).
9B
14
Pipe concealer
SErENiTy 10 BOTTOm ViEw
SErENiTy 37 BOTTOm ViEw
9C
cut pipes to desired
length prior to assembly
9A
22 1/2"
17 1/4"
Blower
Fitting
20 1/4"
16 1/2"
Blower
Fitting
AquAtic industries, inc.