Table of Contents
Advertisement
■ Position data transmission
When a GPS receiver is connected to the transceiver, through
the OPC-966
interface cable
and latitude) can be automatically transmitted. Ask your
dealer or system operator for connection details.
*
This cable is not needed when the HM-170GP
is used as the GPS receiver.
phone
The position data is transmitted:
• When the GPS Request status message is received.
- Set a status message as the GPS Request one in the 'GPS
Request Status' item.
• At the end of a Voice call.
- Set the 'Send with Voice Call' item to 'Enable.'
• After sending a status message.
- Set the 'Send with Status Call' item to "Enable."
• After sending an SDM.
- Set the 'Send with SDM Call' item to "Enable."
• After making an Emergency call.
- Set the 'Send with Emergency' item to 'Enable.'
• After sending an Emergency call with the Man Down function.
- Set the 'Send at ManDown' item to "Enable."
• By the Automatic Position Transmission function.
When the function is activated, the transceiver auto-
matically transmits position data according to the 'Time
Marker' and 'Interval Timer' settings.
- Set the 'Auto' item to "Enable."
NOTE: Configure the position data transmission settings
using the CS-F3160/F5060 (dPMR)
Ask your dealer for details.
,* the position data (longitude
gps speaker micro
cloning software
■ Status message transmission
Status messages can be automatically transmitted:
• When the transceiver is turned ON or OFF.
- Select a status message to be transmitted in the 'Power ON
Status' or 'Power OFF Status' item, respectively.
- Select a target station ID in the 'Power Status ID' item.
-
• At the end of a Voice call.
- Select a Status Message to be transmitted in the 'Send with
Voice Call' item.
NOTE: Configure the status message transmission set-
tings using the CS-F3160/F5060 (dPMR)
. Ask your dealer for details.
ware
.
3
dPMR OPERATION
cloning soft
1
2
3
4
5
6
7
8
-
9
10
11
12
13
14
15
16
26
Advertisement
Table of Contents
