Table of Contents
Advertisement
D Receiving a Group call
q When a Group call is received:
• Rings sound.
• " " appears and the mute is released.
• "
" appears or blinks, depending on the pre-programmed set-
tings.
• The Talkgroup ID (or name) and the calling station's ID (or name)
blink.
• When an All Call is received, "ALL CALL" blinks instead of "TG"
and the Talkgroup ID.
Appears
TG
Talkgroup ID
ID
Calling station's ID
dPMR CALL TXCE CLR
w While holding down [PTT], speak into the microphone at
your normal voice level.
NOTE: Only one station is allowed to speak at the
same time.
e Release [PTT] to receive.
r After the communication is finished, push [Clear] to send a
'Disconnect' signal to terminate the connection.
• Either station can send a 'Disconnect' signal.
• " " disappears, "CLR DOWN" appears for approximately 2 sec-
onds, and the transceiver automatically returns to the stand-by
mode.
Appears or blinks
0100000
0000001
D Receiving a status message
q When a status message is received:
• Rings sound.
• The calling station's ID (or name) and the status message
blink.
The received
status message
Calling station's ID
w Push [Clear] to return to the stand-by mode.
dPMR OPERATION
RX Status 00
ID 0000001
dPMR CALL TXCE CLR
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
14
Advertisement
Table of Contents
