I Position Data Transmission - Icom IC-F70T Instruction Manual

• Available characters
Key Characters
[0]
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
NOTE: A decimal point can only be written with the CS-
F70/F1700
CLONING SOFTWARE
ters can be rewritten with the 10-keypad, except for the
decimal point, as it is not included in the transceiver char-
acter list, and cannot be displayed again.
. Pre-programmed charac-

I Position data transmission

When the optional cable (OPC-966) and a GPS receiver is
connected to the transceiver, the position (longitude and lati-
tude) data can be transmitted automatically.
Ask your dealer or system operator for connection details.
The position data is transmitted when;
• Status 24 message is received
*When the status 24 message, GPS request, is received.
• Fully automatic
When automatic position transmission is enabled, send
the position data according to 'Time Marker' and 'Interval
Timer' settings.
• PTT is released
When 'Send with Logoff' is enabled.
- Set the 'Log-In/Off' item as 'L-OFF.'
• After sending a status message
When 'Send with Status' is enabled.
• After sending an SDM
When 'Send with SDM' is enabled.
• After sending status 22 (Emergency)
When 'Send with Emergency' is enabled.
4
BIIS OPERATION
4
27