Icom IC-F4160DS Operating Manual page 22

Biis 1200/dpmr operation
Table of Contents

Advertisement

3
dPMR OPERATION
■ Transmitting a call (continued)
D Transmitting a Voice Call
NOTE: If you want to make a call to the pre-programmed
ID, skip step q and w and directly go to step e.
q Push [dPMR Button] to enter the ID selection mode.
• The pre-programmed ID is displayed.
w Push [CH Up] or [CH Down] to select a desired Individual
ID or Talkgroup ID.
e Push [Call] to make a Voice call.
• "WAIT" appears while transmitting.
• "CONNECT" is displayed when an acknowledgement is re-
ceived.
• "FAILED" is displayed when no acknowledgment is received.
r After "CONNECT" is displayed, hold down [PTT] and speak
into the microphone at your normal voice level. Release
[PTT] to receive.
t After the communication is finished, push [Clear] to send a
'Disconnect' signal to terminate the connection.
• Either station can send a 'Disconnect' signal.
19
D Transmitting a Status Polling Call
The transceiver can send a signal that causes the target sta-
tion to automatically transmit its current status.
q Push [dPMR Button] to enter the ID selection mode.
• The pre-programmed ID is displayed.
w Push [CH Up] or [CH Down] to select a desired Individual
ID.
e Push [dPMR Button] again to enter the application selec-
tion mode.
• "STATUS" is displayed.
r Push [CH Up] or [CH Down] to select "STAT POL."
t Push [Call] to transmit the status polling call to the se-
lected station.
• "WAIT" is displayed while transmitting.
• When a status message is received, the message and the sta-
tion's ID blink.
• "FAILED" is displayed when no acknowledgment is received.
After a specified time period, the transceiver will return to the
stand-by mode.
y Push [Clear] to return to the stand-by mode.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ic-f4160dtIc-f3162dsIc-f3162dt

Table of Contents