Table of Contents
Advertisement
D Transmitting a status message
You can send a pre-programmed status message to an indi-
vidual station or to group stations.
There are 24 status messages that can be sent, and Status
22 and 24 messages have designated meanings.
Status 22: Emergency
Status 24: GPS request
• Status 22 can also be used as a normal status message by
disabling the designated meaning. However, Status 24 is fixed.
NOTE: Depending on the pre-programmed settings, the
Priority A channel is always used to send status mes-
sages.
BIIS 1200 OPERATION
q Push [BIIS Button] to enter the call code memory mode.
• "
" appears.
• The pre-programmed ID is displayed.
w Push [CH Up] or [CH Down] to select a desired Individual
ID or Group ID.
e Push [BIIS Button] again to enter the message selection
mode, then push [CH Up] or [CH Down] to select a de-
sired status message.
STATUS 01
TX Status 01
BIIS
CALL TXCE MON
A status message is displayed.
r Push [Call] to transmit the status message to the selected
station or group.
• "WAIT" is displayed while transmitting.
• "OK" is displayed when an acknowledgement is received.
• "FAILED" is displayed when no acknowledgment is received.
t After a specified time period, the transceiver will return to
the stand-by mode.
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
8
Advertisement
Table of Contents
