Erasing All Learned Commands From One Component - Universal Remote Control URC-A6 Owner's Manual

Erasing All Learned Commands
from One Component
This function allows you to erase all the
learned commands from one component.
For example, if you want to erase all learned
commands on the TV component button
because you bought a new TV, the process
is very simple.
STEP 1: Press the component button where
all the learned commands are stored and the
[ENTER] button at the same time for two
seconds until the component light turns on.
STEP 2: Press and hold both the component
button you want to erase and the [PAUSE]
button at the same time for two seconds,
until the component light blinks twice to
confirm the erasure.
Replace
with
high
quality
image
Note: If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the programming mode,
and you will have to start over with step
one.
STEP 3: To exit Erase mode, press and hold
both the component button and the [ENTER]
button at the same time until the component
light blinks three times.
Page | 29