Universal Remote Control URC-A6 Owner's Manual page 13

STEP 4: Once the component has turned off,
check your work. Press the POWER ON
button on the URC-A6 remote to turn the
component back on.
Next, test the VOLUME and CHANNEL
buttons (or PLAY and STOP buttons for VCR
and DVD) to make sure they all work. If the
buttons do not work properly, you need to
find a new code. Continue pressing the UP
(or DOWN) arrow button until you find a
new code that turns off the component and
makes the VOLUME or PLAY buttons respond
correctly.
STEP 5: Save your work. Once you have
found the right code, you must save it. Press
the component button you just activated one
more time to save the code number. The
component light will blink three times to
confirm that the code was successfully
stored.
Note: It may take up to five minutes to work
your way through the entire pre-
programmed table. If you cannot find the
right code after 5 minutes of trying the Auto-
Search Method, try the Learning Method
(page 13)
Page | 12