Programming Locations; Programming A Location For A Site; Programming A Location For A Channel Group; Programming General Locations - Uniden UBCD396XT Owner's Manual

23. Programming locations

To use Location-based Scanning
program your scanner with the geographic coordinates you want to use for each
site or channel group. You can also program your scanner to alert you when you
approach particular locations.

Programming a location for a site

Each system site can have separate location information.
1. Open the Program System
2. Select the system you want to program for location based scanning.
3. Select Edit
4. Select the Set LocationInfo
for this site.
5. Change the Set GPS Enable field to On.
6. Go back to the
want to program for this system.

Programming a location for a channel group

Each channel group in a system can have separate location information.
1. Open the Program System
2. Select the system you want to program for location based scanning.
3. Select Edit
location to.
4. Select the Set LocationInfo
for this site.
5. Change the Set GPS Enable field to On.
6. Go back to the
groups you want to program for this system.
Remember: You have to turn on Set GPS Enable before the location
information can affect that site or channel group.

Programming general locations

You can program general locations (i.e., locations that are not associated with a
site or channel group). There are three types of general locations:
 points of interest ( POI )
with a particular system, you will need to
menu.
Site, then select the first site you want to assign a location to.
menu and enter the latitude, longitude, and range
Edit Site menu and repeat these steps with any other sites you
menu.
Group, then select the first channel group you want to assign a
menu and enter the latitude, longitude, and range
Edit Group menu and repeat these steps with any other
UBCD396XT
83