Unpacking And Cleanup; Installing Legs; Handwheels - Jet JPS-10TS Operating Instructions And Parts Manual

Read and understand all
assembly instructions before attempting
assembly. Failure to comply may cause
serious injury.
The main saw unit is heavy;
use of an assistant is highly recommended
when moving or turning it right side up.
Tools required for assembly:
4mm hex key
10mm open-end wrench
Rubber mallet (for wing adjustment)
Cross point (Phillips) screwdriver

8.2 Unpacking and cleanup

1. Remove all contents from shipping carton.
Keep saw table upside down (see Figure 5),
and place a two-by-four or similar piece of
wood under the rear of the saw – this will
help when picking up the table again. Do not
discard carton or packing material until saw
is assembled and running satisfactorily.
2. Inspect contents for shipping damage.
Report damage, if any, to your distributor.
3. Compare contents of shipping carton with
the contents list in this manual. Report
shortages, if any, to your distributor.

8.3 Installing legs

Referring to Figure 5:
1. Install a foot (C) on the bottom of each leg,
using two screws, washers and hex nuts
(HP-6/9/10) for each foot. Hand tighten only.
2. Mount four steel legs (A) to cabinet using
sixteen button head screws (HP-7). Install all
four screws first, then tighten with 4mm hex
key.
NOTE: Remove right side motor cover for
installing last leg screw. (Leave cover off
until wings are installed.)
3. Turn saw right side up and allow the feet to
adjust to floor surface. Tighten hex nuts with
10mm wrench.

8.4 Handwheels

Referring to Figure 6:
The JPS-10TS Table Saw is equipped with two
handwheels which look identical except for the
mounting holes, as follows:
1. On front of table saw, slide bushing (HP-2)
onto shaft (A) followed by handwheel (C)
with the larger mounting hole, making sure
to line up the flat side in the hole with the flat
side on the shaft.
2. Fasten in place with lock knob (HP-1).
3. Slide the remaining handwheel (E) with the
smaller mounting hole onto the shaft (F) on
the right side of table saw, lining up the flat
side in the hole with the flat side on the
shaft.
4. Secure handwheel with lock washer and
screw (HP-11/12), using 4mm hex key.
11
Figure 5
Figure 6