Related Manuals for Jet JTS-315LA
Summary of Contents for Jet JTS-315LA
- Page 1 JTS-315LA Table Saw Original: Operating Instructions TOOL FRANCE SARL 9 Rue des Pyrénées, 91090 LISSES, France www.jettools.com M-10001910AM 2019-03...
- Page 2 CE-Conformity Declaration CE-Konformitätserklärung Déclaration de Conformité CE Product / Produkt / Produit: Table saw / Tischkreissäge / la scie circulaire JTS-315 10001910AM Brand / Marke / Marque: Manufacturer / Hersteller / Fabricant: TOOL FRANCE SARL 9 Rue des Pyrénées，91090 LISSES, France We hereby declare that this product complies with the regulations Wir erklären hiermit, dass dieses Produkt der folgenden Richtlinie entspricht Par la présente, nous déclarons que ce produit correspond aux directives suivantes...
- Page 3 Dear Customer, Many thanks for the confidence you have shown in us with the purchase of your new JET-machine. This manual has been prepared for the owner and operators of a JET JTS-315LA table saw to promote safety during installation, operation and maintenance procedures.
- Page 4 Push stick or push wood must stay with the machine when tool is stored and not in use. Always use the mitre gauge for cutting off. Always wear ear protection when Keep children and visitors a safe The use of dado-blades and groove operating a table saw.
- Page 5 Never operate with the guards not in protection. Dust connection hose and Y-adapter place – serious risk of injury! Use a suitable dust exhaust system. 2 Wheels 2 Carry handles Do not stand on the machine. The use of incorrect mains supply or a Push stick damaged power cord can lead to Operating tools...
- Page 6 WARNING: Attention: Install switch: To avoid injury, if any parts are Insert the switch/plug block (C) into The Support Bracket (U) install as missing, do not attempt to assemble the opening in the leg and secure Fig.3 the machine, do not plug in the power tightly from the side with 2 screw (01).
- Page 7 Install rear extension table:Fit the rear table extension (X, Fig 10). 6. Machine operation Correct working position: In front of the machine standing out of the line of cutting (danger zone). Work piece handling: Hands placed flat on the work piece outside the cutting area.
- Page 8 handling sawblades. 7.2 Mounting the raving knife Rip fence setup shall never be performed when the machine is WARNING: The supplied raving knife must always running. When installing or changing saw be used. blade, always disconnect saw from Use 2 bots and wing nuts (f, Fig 17, Disconnect saw from power source, power source, unplug! Fig.
- Page 9 Please leave it at a needs to be replaced. Contact your specialized institution. Jet service station immediately. 9. Trouble shooting 8. Maintenance and inspection Motor doesn’t start General notes:...