Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Jet JWBS-9X
Summary of Contents for Jet JWBS-9X
- Page 1 JWBS-9X WOOD BAND SAW Original: Operating Instructions Translations: Gebrauchsanleitung Mode d´emploi JPW (Tool) AG Tämplerlistrasse 5 CH-8117 Fällanden Switzerland Phone +41 44 806 47 48 +41 44 806 47 58 www.jettools.com M-10000860M 2017-04...
- Page 2 Déclaration de Conformité CE Product / Produkt / Produit: Band saw Bandsäge Scie à ruban JWBS-9X Brand / Marke / Marque: Manufacturer / Hersteller / Fabricant: JPW (Tool) AG, Tämperlistrasse 5, CH-8117 Fällanden Schweiz / Suisse / Switzerland We hereby declare that this product complies with the regulations Wir erklären hiermit, dass dieses Produkt der folgenden Richtlinie entspricht...
-
Page 3: Table Of Contents
Dear Customer, Many thanks for the confidence you have shown in us with the purchase of your new JET-machine. This manual has been prepared for the owner and operators of a JET JWBS-9X band saw to promote safety during installation, operation and maintenance procedures. -
Page 4: Remaining Hazards
Always wear the approved working outfit Never leave a running machine Wood chips and sawdust can be health - safety goggles unattended. Before you leave the hazards. Be sure to wear personal - ear protection workplace switch off the machine. protection gear such as safety goggles ear- - dust protection and dust protection. -
Page 5: Transport And Start Up
4.4 Machine description 5.2 Assembly If you notice any transport damage while unpacking, notify your supplier immediately. Do not operate the machine! Dispose of the packing in an environmentally friendly manner. Clean all rust protected surfaces with a Fig 5 mild solvent. -
Page 6: Mains Connection
The red button on the main switch stops 7.1 Changing the sawblade To move the fence, raise the clamp and the machine. The sawblade has to meet the technical slide the fence to the desired location. specification. Lower the clamp in order to lock the fence in position. - Page 7 Workpiece setup: - Lower blade guides employ guide pins Bring the upper blade guide to a distance for side support and bearing for rear of approx 0,5cm to the workpiece (Fig 15). support. - Loosen screws (see Fig 13) and move guide pins away from blade sides.
- Page 8 Please leave it at a specialized clean tires. institution. *sawblade has cracks- replace sawblade immediately Cut is not square 11. Available accessories *Table stop setting wrong. Refer to the JET-Pricelist *Blade guide setting is bad for various saw blades.
- Page 11 A8.1 A8.3 A8.2...