Troubleshooting The Jps-10Ts; Replacement Parts - Jet JPS-10TS Operating Instructions And Parts Manual

15.0 Troubleshooting the JPS-10TS

Symptom
Motor will not start
Motor will not start: fuses
or circuit breakers blow.
Motor overheats.
Motor stalls, resulting in
blown fuses or tripped
circuit.
Machine slows when
operating.
Loud, repetitive noise
coming from machine.
Blade not square with
miter slot, or fence not
square to blade.
Blade does not reach 90
degrees.

16.0 Replacement Parts

Replacement parts are listed on the following pages. To order parts or reach our service department, call
1-800-274-6848 Monday through Friday (see our website for business hours, www.waltermeier.com).
Having the Model Number and Serial Number of your machine available when you call will allow us to
serve you quickly and accurately.
Possible Cause
Low voltage.
Open circuit in motor or loose
connection.
Short circuit in line cord or plug.
Short circuit in motor or loose
connections.
Incorrect fuses or circuit breakers in
power line.
Motor overloaded.
Air circulation through the motor
restricted.
Motor overloaded.
Short circuit in motor or loose
connections.
Low voltage.
Incorrect fuses or circuit breakers in
power line.
Applying too much pressure to
workpiece.
Belt loose.
Pulley setscrews or keys are missing
or loose.
Motor fan is hitting the cover.
V-belt is defective.
Blade is warped.
Table top not parallel to blade.
Fence not parallel to blade.
90 degree stop is out of adjustment.
Pointer bracket is hitting before the
blade reaches 90 degrees.
Correction
Check power line for proper voltage.
Inspect all lead connections on motor for
loose or open connections.
Inspect cord or plug for damaged insulation
and shorted wires.
Inspect all connections on motor for loose or
shorted terminals or worn insulation.
Install correct fuses or circuit breakers.
Reduce load on motor.
Clean motor fan with compressed air to
restore normal air circulation.
Reduce load on motor.
Inspect connections on motor for loose or
shorted terminals or worn insulation.
Correct the low voltage conditions.
Install correct fuses or circuit breakers.
Feed workpiece more slowly.
Tighten belt.
Inspect keys and setscrews. Replace or
tighten if necessary.
Tighten fan or shim cover.
Replace V-belt.
Replace saw blade.
Adjust table parallel to blade.
Adjust fence parallel to blade.
Adjust 90 degree stop.
File down the right side of the pointer
bracket until the blade can reach 90
degrees.
Table 2
27