Table of Contents
Advertisement
Assembly
Read
assembly
instructions
assembly! Failure to comply may cause serious
injury!
The required hardware for all assembly on this
machine is found in the Hardware Bag for Stand
Assembly and Hardware Bag for Saw Body.
Unpacking and Cleanup
1. Finish removing all contents from the shipping
carton. Do not discard the carton or packing
material until the bandsaw is assembled and is
running satisfactorily.
2. Inspect the contents for shipping damage.
Report damage, if any, to your distributor.
3. Compare the contents of the shipping carton
with the contents list in this manual. Report
shortages, if any, to your distributor.
Stand
1. Attach the stand braces onto the stand side flat
braces with 8ea M6x16 hex cap screws, 8ea
M6 flat washers, and 8ea M6 flange nuts.
Attach the remaining stand side to the
assembly with 8ea M6x16 hex cap screws, 8ea
M6 flat washers, and 8ea M6 flange nuts.
(Referring to Figure 1~2)
2. Install the foot assemblies into the holes in the
bottom of the stand assembly with 2ea 3⁄8" hex
nuts and 2ea M10 flat washers.
(Referring to Figure 3)
3. Turn the stand assembly upright and attach the
top, with 8ea M8x16 carriage bolts and 8ea M8
flange nuts. (Referring to Figure 4)
4. Square up the stand components and fully
tighten all the fasteners.
and
understand
all
before
attempting
6
Figure 1
Figure 2
Figure 3
Figure 4
Advertisement
Table of Contents
