Table of Contents
Advertisement
6
FREQUENCY PROGRAMMING
I Frequency selection
D D Using the channel selector
q Select a channel which is programmed near the
frequency you want to receive.
w Push [RX
] to select the frequency selection
CLAR
mode.
• "≈" appears in the display.
Ç
"Ç" and frequency show that the
frequency can be changed.
D D Using the keypad
CAUTION: A frequency can be programmed into a
user or e-mail channel by pushing and holding
[ENT] for 1 sec. after entering a frequency. An ITU
simplex frequency can only be programmed on a
temporary basis. Keypad entry should be used only
on spare (or blank) channels.
q Rotate [GRP] and [CH], or enter a 1 to 4 digit num-
ber via the keypad, then push [ENT] to select the
memory channel to be used for general coverage
use.
When a blank channel is selected, operating frequency,
mode and channel name do not appear.
w Push [RX
] to select the frequency selection
CLAR
mode.
• "≈" appears in the display.
e Enter 4 to 6 digits of the desired frequency via the
keypad.
r Push [ENT] momentarily to input the frequency.
• DO NOT hold [ENT] for more than 1 sec., otherwise the
frequency will be programmed into the channel.
14
e Rotate [GRP] to select the digit for tuning.
• Under-bar shows the selected digit.
Ç
The under-bar is moved by rotating
[GRP].
r Rotate [CH] to tune the frequency.
• Pushing [Y]/[Z] on the microphone also tunes the fre-
quency.
t Repeat steps e and r to complete the frequency
selection.
y To return to the previous frequency, push
[RX
].
CLAR
• "≈" disappears.
[EXAMPLE]: Setting 12.3450 MHz
Select blank channel.
Push [RX
]
Ç
CLAR
[1
]
Ç
NB
[2
], [3
],
Ç
SQL
SCAN
[4
], [5
]
×
×
SP
AGC
[0
]
Ç
DIM
[ENT]
Ç
• The set frequency can be cleared when [RX
pushed while setting.
] is
CLAR
Advertisement
Table of Contents
