Table of Contents
Advertisement
10
MEMORY OPERATION
I Memory description
The IC-M801GMDSS has several kinds of memories
as follows:
• Address and group ID code memories (p. 41)
• Call, traffic and scan frequency memories (p. 42)
• DSC transmission memory (described in this section)
• Received message memory (p. 29)
I Memory writing
q During DSC watch mode, select the desired format
category (except distress and test), and set the
message, call and traffic frequencies until the call
stand-by screen is displayed as described in the
CALL PROCEDURE section (pgs. 18–27).
w Push and hold [ENT] for 1 sec. to select the TX
memory write condition.
e Rotate [CH] to select the desired memory channel.
Ç
I Memory reading/transmitting/deleting
q Push [DSC] to select DSC watch mode, if neces-
sary.
w Push [TX
] to enter the DSC transmit memory
TXF
screen.
• Or, push [MODE
" then push [ENT], also selects the transmit
memory screen.
e Rotate [CH] to select the selected memory chan-
nel to be read.
Ç
40
], rotate [CH] to select "
SET
10 DSC transmission memory channels allow you to
set often used format specifiers and contents such as
for routine calls, group calls, etc.
r Push and hold [ENT] for 1 sec. again to store the
condition into the selected memory channel.
• The set DSC format and calling station ID/name ap-
pear.
Ç
t Push [ENT] to return to the calling stand-by condi-
tion, or push [MODE
SET
mode.
r Push [ENT] to display the memory contents.
t Operate as follows:
➥ When reading the memory contents only;
• Push [MODE
] to return to DSC watch
SET
mode.
➥ When transmitting the memory contents;
• Push and hold [CALL] for 1 sec.
➥ When clearing the memory contents;
• Push and hold [CE] for 1 sec.
] to return to DSC watch
Advertisement
Table of Contents
