None Of The Components Operate; Pump Does Not Operate But Light Does; Poor Jet Action - Jacuzzi J-315 Owner's Manual

14.1 None of the Components Operate (e.g. Pump, Light)
Check the following:
. Is there power to the spa?
2. Is the household circuit breaker tripped?
3. Call your authorized Jacuzzi dealer.

14.2 Pump Does Not Operate but Light Does

Press the Jets  Button:
. If no water movement is detected, make sure power is going to the
spa and check the water level. If it does not solve the problem, con-
tact your authorized Jacuzzi dealer.
2. The main pump # operates but no water flows to jets. one of the
Jets pumps may not be properly primed. This can happen after the
spa is drained and refilled. Press the Jets  button several times,
never leaving the pump on for more than 5 to 0 seconds at a
time. Turn power off and let the air out by loosening the cap on the
diverter valve and/or remove the filter, (page 9). Make certain you
tighten the diverter cap and/or reinstall the filter before turning on
spa power and restarting the pump.

14.3 Poor Jet Action

. Press the Jets  button to make certain that jets pump # is on.
2. Depress the air control to the "on" position.
3. Check for dirty filter. Clean, if necessary.
4. Make sure all adjustable jets are open.
J-335, J-345 models include filters on their footwell suction cov-
ers that prevent debris from entering jets pump #2, when oper-
ating. These filters must remain in place to protect jets pump #2
plumbing network. They should be cleaned every 2 months, or
when weak pump #2 performance is observed.
Page 37