Selecting The Skimmer/Heating Mode - Jacuzzi J-315 Owner's Manual

10.4 Selecting The Skimmer/Heating Mode

Press and hold both control panel WARMER ( + ) and COOLER ( - )
buttons at the same time, then release. Then press either WARMER
( + ) or COOLER ( - ) button to select skimming/heater mode F0-F6 or
lock modes L-L2 below.
Standard Skimming/Heating Modes
F0 5 minutes of skimming per day (one 5 minute "Blow-out"
cycle every 24 hours to purge all plumbing lines)
F1  hour of skimming per day (one 30-minute cycle every
2 hours); this is the factory default setting.
F2 .5 hours of skimming per day (one 30-minute cycle
every 8 hours)
F3 2 hours of skimming per day (one 30-minute cycle every
6 hours)
Economy Skimming/Heating Modes
F4  hour of skimming/heating per day (one 30-minute
cycle
F5 .5 hours of skimming/heating per day (one 30-minute
cycle every eight hours)
F6 2 hours of skimming/heating per day (one 30-minute
cycle every six hours)
Lock Modes
L1 Lock out (disables all spa functions to permit filter
cleaning)
L2 Lock Mode (disables the jets and light buttons to prevent
unauthorized use of spa.) Skimming/heater cycle will
continue to operate as programmed in this mode. The
temperature display flashes when this function is enabled.
Example: the "F3" skimming/heater cycle was enabled prior to
choosing lock mode. The spa continues to perform the "F3" cycle until
lock mode is canceled, allowing another cycle to be selected.
To set a time for the first skimmer/heating cycle, simply turn power
on to the spa two minutes prior to the desired time. EXAMPLE: If you
desire your first skimming/heater cycle to begin at 10:00 AM turn off
power to the spa and turn it back on again at 9:58 AM.
Note: start time is approximate and may vary slightly from day to day.
Page 26
every twelve hours)