Warnings And Cautions; Insight Display Errors - HP BladeSystem c7000 Setup And Installation Manual

Warnings and cautions

WARNING!
All troubleshooting and repair procedures are detailed to allow only subassembly/module-level
repair. Because of the complexity of the individual boards and subassemblies, no one should
attempt to make repairs at the component level or to make modifications to any printed wiring
board. Improper repairs can create a safety hazard.
WARNING!
The leveling feet are extended to the floor.
The full weight of the rack rests on the leveling feet.
Bolt the rack to the floor using the concrete anchor kit or raised floor anchor kit attached to
the rack if it is a single-rack installation.
The racks are coupled together in multiple-rack installations.
Only one component is extended at a time. A rack may become unstable if more than one
component is extended for any reason.
WARNING!
Do not disable the grounding cables. The grounding cables are an important safety feature.
Ensure that all enclosures and modules in the rack are grounded to the rack, and that the rack
is connected to a common bonding network.
Do not route the power cord where it can be walked on or pinched by items placed against
it. Pay particular attention to the plug, electrical outlet, and the point where the cord extends
from the server.
WARNING!
Observe local occupation health and safety requirements and guidelines for manual handling
of all enclosures and modules.
Obtain adequate assistance to lift and stabilize the enclosure during installation or removal.
Ensure that the server is properly fastened to the rails.
When mounting the server in a rack, remove the power supplies and any other removable
module to reduce the overall weight of the product.
CAUTION:
at the front and back of the server.

Insight display errors

NOTE: This guide only covers Insight Display errors regarding the power supply. Refer to HP
BladeSystem c7000 Enclosure Setup and Installation Guide for more Insight Display errors at
start-up.
The enclosure installation is successful when all errors are corrected. The errors in the following
sections are specific to installation and initial configuration of the enclosure. To clear errors that
occur after initial installation and configuration, see the HP BladeSystem Onboard Administrator
User Guide for information.
These symbols, on power supplies or systems, indicate that the equipment is supplied by multiple
sources of power.
WARNING! To reduce the risk of injury from electric shock, remove all power cords to completely
disconnect power from the system.
Only authorized technicians trained by HP should attempt to repair this equipment.
To reduce the risk of personal injury or damage to the equipment, be sure that:
To reduce the risk of electric shock or damage to the equipment:
To reduce the risk of personal injury or damage to the equipment:
To properly ventilate the system, you must provide at least 61 cm (24 in) of clearance
Insight display errors 59