Hp Bladesystem Cable Management Tray Installation - HP BladeSystem c7000 Setup And Installation Manual

4. Secure the rear brace to the top brace using the provided screws. The longer flange of the
rear brace must be located on the bottom.
5. From the rear, insert the two rear brackets between the enclosure and the rack. The top tab
rests on the top brace.
6. Insert the top front brackets into the slots in the front of the enclosure.
7. Secure the brackets to the top brace, using the provided screws.

HP BladeSystem Cable Management Tray installation

The HP BladeSystem Cable Management Tray enables you to pass cables from the front of the
enclosure through the tray to the back of the rack. If you do not install the cable management tray,
you must still reserve 2U of space for the cable management tray before installing the second
enclosure.
1. On each side of the rack, align the center holes in the rack with the two center holes on the
rail bracket.
For the lower tray installation, use 12U and 13U.
For the upper tray installation, use 25U and 26U.
34 Installation