"Ca Camshaft Position Sensing Cylinder Support Installation; "Da Camshaft Position Sensing Cylinder Installation - Mitsubishi 4G6 series Workshop Manual

4G6 ENGINE (E - W) -
Timing belt side
Paint mark
Camshaft
position
sensor
E
Mitsubishi Motors Corporation
Rocker Arms and Camshafts (GDI)
(5) Install the beam camshaft cap before the sealant applied
(6) Tighten the bolts to the specified torque in the order shown
(7) Install the camshaft oil seal before the sealant applied
MD998713 (8) Wipe off squeezed out excess sealant from the
"CA CAMSHAFT POSITION SENSING CYLINDER
(1) Apply a 3 mm bead of form-in-place gasket (FIPG) to
"DA CAMSHAFT POSITION SENSING CYLINDER
(1) Set the No. 1 cylinder to the compression top dead center
(2) Install the camshaft position sensing cylinder so that the
INSPECTION
CAMSHAFT
(1) Measure the cam height.
Aug. 1998
becomes dry and hard.
in the illustration.
Specified torque: 20 Nm
becomes dry and hard.
circumference of the beam camshaft cap.
SUPPORT INSTALLATION
the area shown.
Specified sealant:
Mitsubishi genuine
equivalent
INSTALLATION
position (so that dowel pin of the exhaust camshaft is
at the top).
white paint mark is facing in the direction shown in the
illustration.
Standard value:
Intake 35.79 mm
Exhaust 37.14 mm
Limit:
Intake 35.29 mm
Exhaust 36.64 mm
PWEE9616-A
11A-8a-3
Part No. MD970389 or
Added