"Ea Oil Seal Installation; "Fa Sealant Application To Oil Seal Case; Crankshaft Oil Clearance (Plastigage Method) - Mitsubishi 4G6 series Workshop Manual

4G6 ENGINE (E - W) -
Plastigage
E
Mitsubishi Motors Corporation
(8) After installing the bearing caps, make sure that the

"EA OIL SEAL INSTALLATION

"FA SEALANT APPLICATION TO OIL SEAL CASE

INSPECTION
CRANKSHAFT OIL CLEARANCE (PLASTIGAGE
METHOD)
(1) Remove oil from the crankshaft journal and the crankshaft
(2) Install the crankshaft.
(3) Cut the Plastigage to the same length as the width of
(4) Install the crankshaft bearing cap carefully and tighten
(5) Carefully remove the crankshaft bearing cap.
(6) Measure the width of the Plastigage at its widest part
Plastigage
Aug. 1998
Crankshaft, Flywheel and Drive Plate
crankshaft turns smoothly and the end play is correct.
If the end play exceeds the limit, replace No. 3 crankshaft
bearings.
Standard value: 0.05 - 0.18 mm
Limit: 0.25 mm
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent
NOTE
(1) Be sure to install the case quickly while the sealant
is wet (within 15 minutes).
(2) After installation, keep the sealed area away from
the oil and coolant for approx. one hour.
bearing.
the bearing and place it on the journal in parallel with
its axis.
the bolts to the specified torque.
by using a scale printed on the Plastigage package.
Standard value: 0.02 - 0.04 mm
Limit: 0.1 mm
PWEE9616-A
11A-12-5
Revised