"Ca Retainer Lock Installation; "Da Cylinder Head Gasket Identification; "Ea Cylinder Head Bolt Installation - Mitsubishi 4G6 series Workshop Manual

Shank length
Timing belt side
E
Mitsubishi Motors Corporation
4G6 ENGINE (E - W) -

"CA RETAINER LOCK INSTALLATION

MD998772
(1) The valve spring, if excessively compressed, causes the
9EN0062
MD998772

"DA CYLINDER HEAD GASKET IDENTIFICATION

"EA CYLINDER HEAD BOLT INSTALLATION

(1) When installing the cylinder head bolts, check that the
(2) Apply engine oil to the bolt threads and to the washers.
6EN0782
(3) Using the special tool (MB991654) and according to the
(4) Loosen all bolts fully.
(5) Retighten the loosened bolts to a torque of 20 Nm in
Aug. 1998
Cylinder Head and Valves
bottom end of the retainer to be in contact with, and
damage, the stem seal.
Identification mark: 4G63N
shank length of each bolt meets the limit. If the limit is
exceeded, replace the bolt.
Limit: Max. 99.4 mm
tightening sequence, tighten the bolts to the specified
torque.
Tightening torque: 78 Nm
the specified tightening sequence.
PWEE9616-A
11A-9-5
Revised