Operation Mode Selection - Omron SYSDRIVE 3G3EV SERIES User Manual

Constant Dedicated
no. indicator
n51
n52
n53
n67
n68
Note 1. The setting range and factory setting for n31 (electronic thermal reference cur-
rent) depend on the Inverter model. For details, refer to page 4-19 .
Normally, set the rated motor amperage in n31.
Note 2. Displaying the constant no. corresponding to an indicator in the "Dedicated
indicator" column lights the indicator.
Note 3. Constant no. 02 (n02) and subsequent constants can be set only when
constant no. 01 (n01) is set to 1.
Note 4. After setting the Unit no. in n67, turn the power off (make sure that all LEDs go
off), then turn the power on. This makes the setting valid.
Details of Each Constant
Constant Write-Inhibit Selection/Constant Initialization
Setting range
One of the following four values can be selected:
Value
0 Only n01 can be set.
1 Constants n01 to n68 can be displayed and set.
8 All constants are returned to factory settings.
Note If other constants are to be set, always set "1" in n01.

Operation Mode Selection

Setting range
This constant is used to specify whether the Inverter is to be operated with a Digital
Operator or via communication.
Value
0 Digital Operator
1 Communication
Note The above setting operation can be performed when constant no. 02 is selected.
This operation is also possible when the dedicated indicator ("MODE") is lit.
Description
Over-torque detection level
Over-torque detection time
Frequency detection level
Unit no. (see note 4)
Error history
0, 1, 8
0, 1
Run command
Setting range
30 to 200
0.1 to 10.0
0.0 to 400
0 to 15
(Display only)
Factory setting 1
Description
Factory setting 1
Frequency reference
Digital Operator
Digital Operator
Chapter 4
Factory setting
160 (%)
0.1 (seconds)
0.0 (Hz)
0